Ramps not connecting in a conventional manner.
in Bug Reports
What I found very strange is how the ramps connect to beams at an even block gap between the beams, they will not connect, however if you extend the ramp up and over the beam, it will connect:
The same results occur during incline too:
Additionally, I tried seeing how far I could make this mismatched ramp go, and it can go 6 blocks while on beams, but cannot reach when placed directly onto the blocks:
I'm pretty sure this is a bug as I showed DrWhoCares about it and he is pretty sure it is a bug too.
The same results occur during incline too:
Additionally, I tried seeing how far I could make this mismatched ramp go, and it can go 6 blocks while on beams, but cannot reach when placed directly onto the blocks:
I'm pretty sure this is a bug as I showed DrWhoCares about it and he is pretty sure it is a bug too.
Comments